thankyouOB wrote:DarkStar wrote:Just checked and mine is still set to 30 amps. I verified the CDMA modem is still in there, but since Blink cancelled the service the log shows there is no modem.
If you want to manually change your current, here are the instructions:
On the Blink, click on Settings, then Device Info. Press on the 30A under Maximum Current and hold your finger there for at least 10 seconds. This will take you to a screen asking for the code, the current code is 906598. Then you'll be in Maintenance Mode and be able to change the Maximum Current.
i tried that last graf, and nothing happened when i held my finger on 24A.
I had the same problem. At first nothing happened. I had to try 3 or 4 times and holding/or tapped hard and holding finger on slightly different locations over the 24A for more than 10 seconds. Finally got access, but didn't make a change at this time.
The logs showed several things in August:
Aug 8 they Checked that the J1772 Duty Cycle was currently set at 30 Amps
- Some process monitoring change daemon
- A GPS Service Request
Aug 19 Device Amperage successfully changed to 24 amps.
- some back office update, and some network timeouts during some uploads...
Greek to me.
Firmware Version is 2.1.20130801 E1.10