gbarry42 wrote:So, my charge current limit was raised today...to 24A ( -->see previous message). Good news is that the firmware didn't change, and neither did the ability to change the current again in the future
BTW, when they change it, it goes into the log.
gbarry42 wrote:I'm not inclined to take it off the network. Maybe if I changed the setting myself they would pass over as not needing it (worth a shot).
JPWhite wrote:Well spotted batman!! Mine has changed now as well.
(mine was reset to 24A).
I like being able to manipulate the box from my computer, otherwise I would disconnect it. i think it is a good thing to share the data for the EV movement.
DarkStar wrote:Just checked and mine is still set to 30 amps. I verified the CDMA modem is still in there, but since Blink cancelled the service the log shows there is no modem.
If you want to manually change your current, here are the instructions:
On the Blink, click on Settings, then Device Info. Press on the 30A under Maximum Current and hold your finger there for at least 10 seconds. This will take you to a screen asking for the code, the current code is 906598. Then you'll be in Maintenance Mode and be able to change the Maximum Current.