hubaksis wrote:Hi everyone,
I think this is the best topic to ask.
I found out that some values can be requested from a module only after setting it into diagnostic mode by sending a command 02 10 C0.
However, I can't find any details about this mode.
Can you tell me, does it have any expiration time? If so - is there a command to keep it active or just send another one 02 10 C0?
Do I need to exit diagnostic mode after I finished all requests?
I think it exits in about 1-2 seconds. 02 3E 01 will keep it alive if sent once a second. No harm in not exiting. It will timeout anyway.