Hi Turbo, this is Frank (the 1st unlucky one to have a defective Konnwei, we talked via email).
So I have 2 bad ones now, one from Aliexpress and one from Amazon. I saw the fix, removing the little resistance you show on the picture... I did that, but, before I go ahead and brick my Leaf, I'd like to see if I did this correctly:
1st off, I could barely see anything there, we are talking microscopic almost! Anyways, I saw something, and flicked it off with my fingernail, and it came out. Really small stuff.
Then I re-tested the resistance, and now the needle does not move at all when testing pin #6 to pin #14. Is that a good sign, or should it have gone back to 120 ohms?
If this is right, then I will plug it in and see what happens. I'll probably fix the 2nd one too instead of returning it, I could use it with Torque on my other car I guess.
Thanks for all the help!