Hi ticktock,
I am planning on using a complete leaf pack in a home energy recovery system, still utilising the original bms etc... I am looking at a microcontroller to extract cell voltages, pack voltage and temps exactly as you have done with your code and visual display. I intend to use leafspy as a display but I need a controller and code to switch off the charger and discharge relays to protect the battery, all this can be done utilising the eh outputs from a microcontroller and utilising your code.
Could you please specify what type of controller you used to talk to the bms and extract all the data, plus could you share the code with me please.
I'm not good at programming but I'm sure I could with a few extra lines of code to switch on and off n output to end charge / discharge of cells are high, low or hot.
Many thanks, and I lave the way this thread is helping others.
Best regards, Anthony.
TickTock said:
Thanks again Greg! Just finished coding it up. Here's the money-shot.