I have an issue when I scan e-NV200 van using LeafSpy Pro or just requesting data with arduino. It doesn't work.
It works only while I drive, but not while charging. (by the way, the Fast charge counter in LeafSpy is always 0)
I connected to the CarCAN with arduino and found out that there are no any messages in the canbus while charging. It's asleep.
If I open or close the door - it awakes and everything works for about 30-60 seconds. Then nothing again.
As opening and closing the door for a few hours is not an option, how I can get data from the car while it's charging? Any ideas?
Is there a possible message that can be sent to keep it awake for a while?
Thanks.
It works only while I drive, but not while charging. (by the way, the Fast charge counter in LeafSpy is always 0)
I connected to the CarCAN with arduino and found out that there are no any messages in the canbus while charging. It's asleep.
If I open or close the door - it awakes and everything works for about 30-60 seconds. Then nothing again.
As opening and closing the door for a few hours is not an option, how I can get data from the car while it's charging? Any ideas?
Is there a possible message that can be sent to keep it awake for a while?
Thanks.