Recent content by ETrrijal2

I have not, I have a similar set up, I was able to read the can and send the data. I think I was not able to send the correct data or in a correct manner, but I was not able to turn that on for now. I will be starting that project later but for now I bought elcon charger.

Could you please provide the full code? I have send all the messages as show. I have connection of 12v, ground and CAN high and CAN low. I am not seeing any DC voltage after sending these code?

I have not connected anything except for 2, 12 volt power supply and ground. I did got change to take data from working OBC and tried to put to that message still not progress. While getting the datas I found out that the values of 0x1D4, 1F2 has more than for different values and I am trying...

Thanks Peter, I have changed the message bytes that you used and replaced with message that Truesoln used. I read in page 5 of this page that he was able to turn the charger on and used his message. I would love if anyone has recording of the CAN message. Since I don't have the working 2012...

I am trying to run OBC 2012 and used the code by @49driver(for timing) and TrueSoln(message needs to be sent). Below are the messages that needed to be sent but my charger is still off. In the TrueSoln code snipped he has nissan_crc(messageData, 0x85); function which does-not provide any detail...

@TrueSoln I am working OBC gen1 and trying to get the charger working. I used @49driver code for gen2 and it seems like it is now woking. Can you send or upload code foe gen1.