My Nissan Leaf Forum

Help Support My Nissan Leaf Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
N
Reaction score
8

Latest activity Postings About

    • N
      NJLeaf27 replied to the thread 2012 Leaf: PDM, OBC, or both?.
      You guys have been so helpful, I can't thank you enough. Because of you two I just became a supporting member. I'm the same way when I...
    • N
      NJLeaf27 replied to the thread 2012 Leaf: PDM, OBC, or both?.
      Oh, that's interesting. The DC lines go straight to the HVJB which make sense, but the rest of the CHAdeMO communication lines are from...
    • N
      NJLeaf27 replied to the thread 2012 Leaf: PDM, OBC, or both?.
      Well, I got the power board out. Whoever designed the bracket that supports the relay on the bottom right should be shot. It curves...
    • N
      NJLeaf27 replied to the thread 2012 Leaf: PDM, OBC, or both?.
      Are you sure the OBC has anything to do with DC charging? The CHAdeMO cable goes straight to the HVJB, and the OBC is in the back of...
    • N
      NJLeaf27 replied to the thread 2012 Leaf: PDM, OBC, or both?.
      That sounds right, because the manual says 2850A is when either temp sensor 1 or 2 are out of range, and 2850B is if the two are...
    • N
      NJLeaf27 replied to the thread 2012 Leaf: PDM, OBC, or both?.
      I actually didn't remove the 4 fastons on the left, only the ones on the right. After removing the ones on the left, the only points I...
      • IMG_7357.jpg
    • N
      NJLeaf27 replied to the thread 2012 Leaf: PDM, OBC, or both?.
      It's kind of funny because when I started testing on the upper right, I was testing forward and reverse, and was always getting 0's in...
    • N
      NJLeaf27 replied to the thread 2012 Leaf: PDM, OBC, or both?.
      Well that stinks, but thanks for all the help. Hopefully this thread will help others. I might be interested in having it fixed. I’ll...
    • N
      NJLeaf27 replied to the thread 2012 Leaf: PDM, OBC, or both?.
      My board also has a thick protective coating on the solder joints. I'm scraping off the tips of the pins and touching my probes at the...
    • N
      NJLeaf27 replied to the thread 2012 Leaf: PDM, OBC, or both?.
      Sorry, I mistakenly said 17 ohms for 9-10 when I meant 17 kiloohms. 17-18 also reads 17k, same as what nlspace is getting. But 11-12 I...
    • N
      NJLeaf27 replied to the thread 2012 Leaf: PDM, OBC, or both?.
      I checked everything else on coulomb's diagram and most of it checks out, except I'm a little confused by the middle left part. I don't...
    • N
      NJLeaf27 replied to the thread 2012 Leaf: PDM, OBC, or both?.
      Oh, I didn't notice the different color writing on the side of the resistor. Across the blue wire I read 4.4 ohms, and the yellow...
    • N
      NJLeaf27 replied to the thread 2012 Leaf: PDM, OBC, or both?.
      Green ceramic? Is that the blue capacitor? Back up a minute. I did something stupid. Those Fastons are no joke to remove on the blue...
    • N
      NJLeaf27 replied to the thread 2012 Leaf: PDM, OBC, or both?.
      Can't tell if that blue cap is leaking or if it was just some extra plastic. It looks like a little skin tag sticking out the side of...
    • N
      NJLeaf27 replied to the thread 2012 Leaf: PDM, OBC, or both?.
      I decided to pull the OBC out of the car. Here are the photos of the circuit boards. Nothing looks obviously blown, except on the side...
      • IMG_7312.jpg
      • IMG_7314.jpg
      • IMG_7315.jpg
      • IMG_7316.jpg
  • Loading…
  • Loading…
Back
Top