Nissan Leaf HV Battery to OBD2 36 pin adapter wiring

[LindseyP]

I would like to verify if I have this wired correctly? I bought the connector from Aliexpress to potentially use when verifying the life left in a used battery pack. My 2015 SL has a 24kwh pack that just dropped below 80%, I don't do alot of long distance driving but I figure I will need to upgrade it in the next year or two as it continues to drop... Looking at hitting the wrecking yards in my area when that time comes (the packs from China are too expensive and too unkown just yet - I'll wait a while before going that route!)
I have already assembled Dala's 2-port canbridge so that is ready and waiting, I just want to make sure I have read his github wiring diagram correctly before sealing up the wires on my 36-pin connector. Can anyone who built this confirm the wiring is correct??

https://github.com/dalathegreat/Nis.../master/Documentation/HowToWireItUp_2013+.png

 

[nlspace]

Looking at hitting the wrecking yards in my area

whereabouts is that area?

Why not use the wire color called out for B24?

Is there some benefit to using the same color for all the wires?

 

[LindseyP]

Okanagan BC Canada

These were extra wires from the ST Link V2 fasher for the can-bridge I purchased and already had the correct connector attached.

And they will all be hidden by silicone/tape/heatshrink/nylon cover so won't be visible at all!

;-)

 

[Jarichus]

When using a B24 connector to OBD2 test cord be sure to set LeafSpy Pro to BMS only settings. I made the Data connector twice before I found out about the settings.