I just wrapped up the initial design of my 3d-printable & modular grille blocker
Specifically AZ0 2011-2012 Leafs, are they any different compared to 2013-2017 AZE0-0 and AZE0-1?
https://github.com/dalathegreat/Nissan- ... mod-Grille
Printed in black PETG (PLA / ABS also works, if you use PLA remember to clear-coat it so it holds)
It prints in 4 sections, so you need a printer that can handle 18cm / 7inches minimum. Here's a picture of it mounted on my car, had to crank up the brightness so you can actually see something