Take an ELM trace and send it to me. See bottom of help file for how to do it.tomgilman wrote:I understood the SOH value to be one of the key easier to understand values, but mine is zero. Not sure what this means. I see the screenshot on the iTunes app store also has a value of zero. Any hints or suggestions are appreciated.
When you get to state ELM 11 you have connected to the WiFi OBDII adapter but the adapter is not receiving data from the Leaf. This is normally because the Leaf in not on (dash gauges active) but since you were driving that is not the case. The leaves two other possibilities. One is the adapter does not support the needed commands and the other is a defective OBDII adapter. In either case I will need to see an ELM trace. For instructions on how to take an ELM trace see the bottom of the Help file. Send the trace (TRC_xxxx.txt) file to the contact address below.willmkz wrote:Hi,
I am a new LeafSpy Pro user and am having trouble connecting to my iPhone. Please would you let me know where I am going wrong?
I am using the OBD II wifi dongle below:
https://www.amazon.co.uk/Pumpkin-Interf ... dongle+ios
I have used IP adress: 192.168.0.123
I have used Subnet Mask: 255.255.255.0
Following the instructions I receive a yellow box in the bottom right corner and with the leaf turned on I receive the "Retry ELM 00" Error code. Note that the app connects to the dongle and WiFi_OBDII is visible at the bottom of the screen.
I left the connection open whilst driving to work, and the error changed to "Retry ELM 11".
Is there any obvious mistake that you are aware of that could cause this?