garygid wrote:How much was the enclosure from Shapeways?
Does it include a screw-on back?
What was the shipping cost?
What would it have been the cost if they made 10 at one time?
The cost for one from Shapeways was $25.56 plus $6.50 for shipping.
I doesn't include a back. I made one from scrap white acrylic I had on hand.
There doesn't appear to be a quantity discount when I selected a quantity of 10, same shipping though.
Most of the side walls are near the minimum so this design would not hold up to much abuse.
Just needed to get something so that the board was a little bit better protected.
Once I finish a new LeafCAN board layout, I will most likely design a sturdier enclosure and make the files available.