Gold Member
Posts: 858
Joined: Wed Jan 09, 2019 10:51 pm
Delivery Date: 10 May 2018
Leaf Number: 004270

Re: 200V AC Japanese EVSE on 230V AC NZ Power system: Any probs?

Fri Mar 29, 2019 7:42 am

The only issue I could see is it maybe could fry the metal oxide varisistor.
When I converted my evse from boring US 120v power to use 240v US power I had to remove the MOV surge protector and install my own.
The control transformer may get hot running the slightly higher NZ voltage.
But if everyone is doing it is probably fine.
Do you know what the 230v power there actually reads on a multi meter?

More than likely they are using 300v MOVs on 200 and 230v systems.

I did not have to replace my control transformer because in the US we use 120/240v center tapped transformers. So all I did was run transformer primary wires from one of the lines to ground. So the transformer still gets 120v power to it.
This is not really allowed but oh well.
2011 white SL leaf with 2014 batt.
Chargers: Panasonic brick moded for 240v, duosida 16a 240v and a 10kw setec portable CHAdeMO
Location: 88103

Forum Supporter
Posts: 1493
Joined: Sun Dec 18, 2011 7:14 pm
Delivery Date: 20 May 2013
Leaf Number: 410357
Location: Anaheim

Re: 200V AC Japanese EVSE on 230V AC NZ Power system: Any probs?

Fri Mar 29, 2019 8:04 pm

Japan uses 100 V and 200V. The us uses 120V and 240V. Some European countries use 220V and a 200V EVSE should work fine. A 100v EVSE will not; Most Leaf;s are calibrated for 100V charging. Thus the time for L1 charging is off. It is merely cosmetic since who looks at the charging time?
2013 Pearl White SL Premium
Traded for a Cirrus White 2014 Mercedes B (totaled)
2016 Urano Gray eGolf SEL w/ drive assist
Loved the VW but it sat too low for my old body
Back to a Cirrus White 2017 B250e
White Ioniq limited.It sits just fine

Posts: 1
Joined: Mon Sep 16, 2019 1:21 am
Delivery Date: 16 Sep 2019

Re: 200V AC Japanese EVSE on 230V AC NZ Power system: Any probs?

Mon Sep 16, 2019 1:36 am

The generation 2 leaf EVSE doesn't need the 230v transformer rectifier unit, but when you cut the cable to change the Japanese plug for a NZ caravan plug there are two additional yellow wires. These need to be joined with a 10kOhm thermistor between them, which can be bought from Jaycar. I used a strip connector because soldering might cause issues with the thermistor. The thermistor is a temperature sensor which reduces the amperage if the plug heats up.

Return to “New Members & Newbie Questions”