The correct hatch harness is 24052-3NF0C
, not B. Perhaps you made a typo in your post? If not, my 2103 SL had the correct 'C' harness already, check that yours may also have had the correct harness to begin with.
Have you carefully inspected the large connector on the front-to-back body harness in the rear pillar, where the hatch-to-body harness plugs in? I was pleasantly surprised to find that mine had the pins and wires needed for the camera, but many people did not and had to run their own wires from front to back, splicing them into the body-to-hatch wiring and the corresponding connector at the front (under the trim panel in front of the driver's door by your left foot).
Brayne wrote:I know this is an old thread but I'm hoping someone can point me in the right direction. I have been meticulous in following the instructions. And THANK YOU for your time for posting this! I have a '13 SL with QC, Navigation and the larger screen, but no all-around view (no back up camera.). The car was originally delivered end of Feb. of that year if that makes any difference regarding anything.
I have purchased and installed the following parts according to the OP instructions.
Harness body/hatch - 24051-3NF0B
Harness Back Dr - 24052-3NF0B
Handle - 90606-3NF2B
Camera - 28442-3NH0B
Camera Screw - 01454-N5021
All installed just fine and very straight forward however, no camera view while in R. Bummer! Can someone with experience please be so kind to point me in the right direction to start the troubleshooting process? I am anxious to get my new toy working.