Brightonuk
Well-known member
Have we tested the meter on a 2012 yet?
garygid said:O
You probably have a 12v power supply with a PowerPole connector, and made a PP to OBD adapter to plug the SOC-Meter into, right?
Happy Thanksgiving, Gary
garygid said:5. Run the "SocMeterUp.bat" file to start AVRdude, which will automatically clear the flash memory, write the new program, read and verify the results, and re-boot the SOC-Meter.
\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\
2. A ".bat" file to supply the needed parameters to AVRdude and run it.
I will post this short file.
\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\\
pause
:avrdude.exe -?
:pause
: -p device
: -P port
: -v = verbose
: -B bit-clock-period-us
: -U memtype:write:file:format ... flash memory (w=write) i=?
: -c programmer-type
:echo ---
:echo AT90CAN128 = c128
:echo COM5, 19200, xmit Buff = 1 to 16 OK, Rec buff = 1 to 14 OK
:echo programmer = jtag1 or jtagmkI, just verbose, 8 usec/bit
:echo ---
echo *************************************************
echo ** flash write spy.hex format=i (Hex) **
echo ** Ctrl-Pause (Break) to Terminate Program **
echo *************************************************
pause
avrdude.exe -p c128 -c jtag1 -P COM5 -v -B 8 -U flash:w:"D:\Prog\Spy-Gg4p\spy.hex":i
pause
pause
avrdude.exe -?
pause
: -p device
: -P port
: -v = verbose
: -B bit-clock-period-us
: -U memtype:write:file:format ... flash memory (w=write) i=?
: -c programmer-type
:echo ---
:echo AT90CAN128 = c128
:echo COM5, 19200, xmit Buff = 1 to 16 OK, Rec buff = 1 to 14 OK
:echo programmer = jtag1 or jtagmkI, just verbose, 8 usec/bit
:echo ---
echo *************************************************
echo ** flash write spy.hex format=i (Hex) **
echo ** Ctrl-Pause (Break) to Terminate Program **
echo *************************************************
pause
avrdude.exe -p c128 -b 19200 -c jtagmkI -P COM5 -v -B 8 -U flash:w:"D:\Prog\Spy-Gg4p\spy.hex":i
pause
garygid said:I just included extracts from my BAT files (for programming the
AVR-CAN board) with AVRdude ... in the post above.
garygid said:Dan,
You might want to leave room/provision for placing a thin filter
over the display, so that it can be read in sunlight.
See my SOC-Meter Filter thread for how to email me, and
I will send you a "frame" (filter holder, not perfect, but
the best I could find online) and a Blue filter.
roperld said:What do the two toggle switches on the SOC meter do?
roperld said:What do the two toggle switches on the SOC meter do?
mwalsh said:roperld said:What do the two toggle switches on the SOC meter do?
I don't remember about the bottom one, but the top one is power on (to use with charging)-off-power on with vehicle operation.
Enter your email address to join: