garygid
Well-known member
1. Carefully inventory your parts before you start building.
BIG Parts:
1. Box (with lid, and 4 screws inside)
2. OBD cable (6' or possibly 9')
3. Tube of RTV Sealer ("glue")
4. Roll of Electricians Tape
5. Box with AVR-CAN board & Display (check color)
6. Bag of small Parts
7. Instructions: Wiring Diagram, Hole Template, and possibly more
Small Parts:
1. Switch, toggle, On-Off-On, single pole (Power Switch)
2. Switch, toggle, On-Off-On, double pole (CAN-Selector)
3. Two Push-buttons: Red and Black cap (user input)
4. Zener Diode, 5.1v, 1 watt
5. Shrink Tube, thin, about 1"
6. 9-pin "D" connector, female, solder-style pins
7. Housing for crimp-pins, one 4x2, one 6x1
8. Six wires with crimp pins, about 3" (Green, Red, Orange, Gray, and two Black)
9. Four wires, about 3" (Red, Black, White, Gray)
------------------
BIG Parts:
1. Box (with lid, and 4 screws inside)
2. OBD cable (6' or possibly 9')
3. Tube of RTV Sealer ("glue")
4. Roll of Electricians Tape
5. Box with AVR-CAN board & Display (check color)
6. Bag of small Parts
7. Instructions: Wiring Diagram, Hole Template, and possibly more
Small Parts:
1. Switch, toggle, On-Off-On, single pole (Power Switch)
2. Switch, toggle, On-Off-On, double pole (CAN-Selector)
3. Two Push-buttons: Red and Black cap (user input)
4. Zener Diode, 5.1v, 1 watt
5. Shrink Tube, thin, about 1"
6. 9-pin "D" connector, female, solder-style pins
7. Housing for crimp-pins, one 4x2, one 6x1
8. Six wires with crimp pins, about 3" (Green, Red, Orange, Gray, and two Black)
9. Four wires, about 3" (Red, Black, White, Gray)
------------------