So CanBus message on bytes 4 and 5 of 0x1DA reads RPM. Does anybody know the proper scaling for this value to get actual RPM of motor?
I use the Leaf system in another vehicle without the gearbox so it is a little harder to figure it out mathematically.
Multiplying x10 is too high, as the value read 14,200 at one point.
Anybody? Thanks!
I use the Leaf system in another vehicle without the gearbox so it is a little harder to figure it out mathematically.
Multiplying x10 is too high, as the value read 14,200 at one point.
Anybody? Thanks!